Log Home Restoration in Victor, ID: 4 Jobs, Honest Prices
Log home restoration in Victor is home ground. Log Care works out of Victor, Idaho and has since 2008. Your project does not carry a drive to it, the crew knows the roads, and the assessment happens on your schedule instead of ours.
Victor sits at the south end of Teton Valley at the foot of the pass, which means big sun on open lots, cold air settling on winter nights, and snow that stays late on any wall that does not see the sun.
What Victor does to a log home
Cold air that pools in the valley
Teton Valley collects cold. Hard freezes drive moisture that soaked into a check or a joint deeper into the log, and every freeze-thaw cycle opens both a little wider.
Open lots, full UV
There is little natural shade on most of the valley floor. South and west elevations take the full load and are usually two to three years ahead of the shaded sides on the failure clock.
Snow that stays late on the shaded side
North walls hold snow into spring. Anywhere snow sits against a wall, the bottom courses stay wet long enough for decay to start.
Runoff off the pass
Victor takes water coming down out of the canyon. Where a roof or a grade sends runoff at a wall, the logs at the bottom pay for it.
The four jobs a Victor log home needs
Media blasting · $3–$6 per sq ft
Strips failed stain, paint, mildew and gray UV-damaged fiber back to bare, bondable wood using recycled crushed glass, corn cob or walnut shell. New finish will not bond to gray fiber. Log home media blasting.
Log rot repair · $250 to $5,500
Priced by method, decided by a probe: borate treatment, epoxy consolidation, a Dutchman patch, half-log facing or a full log. Water is almost always the cause, so we fix the water too. Log home repair.
Staining and sealing · $1.40–$10 per sq ft
A breathable, penetrating stain goes on bare, sound wood within days of the blast, before UV can gray it again. Cost tracks prep, not paint. Log home staining.
Chinking and caulking · $12–$22 per linear ft
Failed material removed, joint prepped, backer rod installed, new chinking applied over a finished surface so it bonds. Done right it lasts twenty years or more. Chinking and caulking.
We also handle thermal imaging, log carpentry, house painting, pressure washing and window washing. Everything is on the services page.
Victor and the towns around it
Victor is part of our Teton Valley service area, along with Driggs, Tetonia and Alta. We cross the pass daily into Jackson Hole and work south into Star Valley. Every town is listed on the service areas page.
Log home restoration questions from Victor owners
How much does log home restoration cost in Victor?
Media blasting runs $3 to $6 per square foot of log surface, staining $1.40 to $10 per square foot depending on prep, a full re-chink $12 to $22 per linear foot, and rot repair from a $250 patch to $5,500 for a jacked sill log. Most whole-house projects land between $15,000 and $60,000. See log home restoration cost.
Is there a discount because you are based here?
There is no drive time and no mobilization to build into a Victor quote, and that shows up in the number. The assessment is free, the scope is written, and nothing is priced from a photo.
Can you look at it this week?
Usually. Victor is the shortest trip we make. If the finish is peeling, the chinking is pulling away or you have found a soft spot, call and we will get someone out.
How often should a Victor log home be restained?
South and west walls every three to five years, north and east walls every five to eight. The quickest test is whether water still beads on the wall — when it soaks in, the repellent is spent. Blasting back to bare wood is typically needed every seven to ten years.