Log Home Restoration in Driggs, ID: 4 Jobs, Honest Prices
Log home restoration in Driggs covers the middle of Teton Valley — town lots, subdivisions off Highway 33 and the ranch roads running out toward the Big Holes and Grand Targhee. It is a fifteen-minute drive from our shop in Victor.
Driggs homes sit on open ground under a big sky, and that combination of full sun, hard winters and very little tree cover is why finishes here fail faster than owners expect.
What Driggs does to a log home
Wide open sun exposure
Almost nothing shades a wall on the valley floor. South and west elevations take the whole UV load, and on darker stains they can be chalking at four years.
Deep cold and freeze-thaw
Long hard freezes push water deeper into checks and joints, and every cycle widens them. Upward-facing checks are the ones that matter, because they hold water.
Wind off the flats
Wind across open farmland drives rain and snow horizontally into joints. On a lot of Driggs homes, the west-facing chinking needs attention before the rest of the perimeter.
Newer homes on older finishes
A house built in the last twenty years can still be on a failed first finish. Age of the house is not the question — age and condition of the finish is.
The four jobs a Driggs log home needs
Media blasting · $3–$6 per sq ft
Strips failed stain, paint, mildew and gray UV-damaged fiber back to bare, bondable wood using recycled crushed glass, corn cob or walnut shell. New finish will not bond to gray fiber. Log home media blasting.
Log rot repair · $250 to $5,500
Priced by method, decided by a probe: borate treatment, epoxy consolidation, a Dutchman patch, half-log facing or a full log. Water is almost always the cause, so we fix the water too. Log home repair.
Staining and sealing · $1.40–$10 per sq ft
A breathable, penetrating stain goes on bare, sound wood within days of the blast, before UV can gray it again. Cost tracks prep, not paint. Log home staining.
Chinking and caulking · $12–$22 per linear ft
Failed material removed, joint prepped, backer rod installed, new chinking applied over a finished surface so it bonds. Done right it lasts twenty years or more. Chinking and caulking.
We also handle thermal imaging, log carpentry, house painting, pressure washing and window washing. Everything is on the services page.
Driggs and the towns around it
Driggs is part of our Teton Valley service area, along with Victor, Tetonia and Alta. We cross the pass daily into Jackson Hole and work south into Star Valley. Every town is listed on the service areas page.
Log home restoration questions from Driggs owners
How much does log home restoration cost in Driggs?
Media blasting runs $3 to $6 per square foot of log surface, staining $1.40 to $10 per square foot depending on prep, a full re-chink $12 to $22 per linear foot, and rot repair from a $250 patch to $5,500 for a jacked sill log. Most whole-house projects land between $15,000 and $60,000. See log home restoration cost.
Do you charge extra to come to Driggs?
No. The shop is in Victor, fifteen minutes away. Teton Valley is the shortest drive we make and the on-site assessment is free anywhere in the county.
My home is only ten years old. Does it need this?
Possibly. Ten years is more than a full cycle for a south wall here. The finish, not the house, sets the schedule — if water no longer beads on the wall, the repellent is spent regardless of how new the building is.
How often should a Driggs log home be restained?
South and west walls every three to five years, north and east walls every five to eight. The quickest test is whether water still beads on the wall — when it soaks in, the repellent is spent. Blasting back to bare wood is typically needed every seven to ten years.